Three years ago I looked into properly wiring hotends with quick toolhead swapes and came up with this: Combining the entire hotend wiring into 3x shielded 4-conductor cables (thin cables for small drag chains with tiny bending radius) and options to terminate the shield. The static side features an USB-port to retrofit Raspberry Pis and a step down to generate the 5V supply from a single 12 or 24V power input.
For the moving side/hot-end PCB it’s a similar story:
Why did it all fall apart? BOM cost.
Those connectors with locking lever for easy removal cost a fortune and the 3D-printing world moved on to CAN.
For the active version of this, it’s a different story. Never figured out how to make it plug-and-play/foolproof (active circuit for safety features (contact resistance, overtemperature, fan failure, etc.) as well as preemptive maintenance (heater wear, fan bearing degradation, and more).
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)
Moderation policy: Light, mostly invisible
Your idea was a good one. In the Voron world, toolhead PCBs are very much a thing for basically exactly the reasons you listed. There are both CAN and non-CAN versions available.
I suspect to know some of this though, given your mention of drag chains and heated enclosures…
I just put a toolhead board on one of my ender 3s a couple weeks ago, it was a pain in the ass and not necessary in any way but I’ve since pulled the toolhead off twice and both times it was nice just detaching the single connection and being able to move to my desk to do the work.
A little bit more background: I wanted a small drag chain with a bending radius not larger than the height of the toolhead.
more conductors = thicker cable = larger bending radius = bad (this application)
What can I do?
multiple cables = more cables but thinner = smaller bending radius = good
What drag chains can I buy?
At most I can fit 3 cables within those small chains. How many conductors do I have to work with? 12
4 conductors are required for the stepper motor. This means I have a total of 8 left. With some combining (e.g. not running nets/connections that would be anyway joined on the mainboard) and generating the voltages locally you can actually wire an entire hotend with 8+4 conductors. None of the commercials available have done that. With the CAN options it’s nolonger an issue as there are cables with thick power/GND conductors and controlled impedance for the two CAN data lines.