OK, but that is a totally different topic than electric trucks are bad, which was the start of this discussion. Do I think that there should be less trucks on the road, yes. When I was younger, you didn’t own a truck unless you regularly hauled stuff in the bed, or towed stuff. Now people own them just because. But again, you have totally changed the topic here.
I just bought that dongle this weekend. I’m setting up my first HA instance. You can flash a firmware on that dongle that also adds thread/matter support so you have both on one dongle.
I was having an issue like this last week, and surprisingly, I was able to finish my print by using a new slicer. I was all prepared to go buy a new board for my ender3v2. I had even put a bigger fan on the board to try more cooling but still kept getting it on this large print. I sliced it in superslicer instead of cura, and it printed. Unless you’re just eager to spend money and replace parts, not necessarily a bad thing, I would take a stab at a different slicer first.
Well duh